You will need to access the zipper to be able to open it and turn the pouch inside out. Trim off the excess fabric to leave about 1/4″ seam allowances. You are all done! Simply tear the pouch out of the stabilizer. Tape it in place in a few spots and start the next round of stitching. Now, lay your back piece down (right side of fabric down) on top of the placement stitching. The folded end of the ribbon should be on the inside of the pouch. Tape it down to the fabric so that the two raw edges overlap the stitch line you just created. Step 12įold your ribbon in half along the short edge. This is a placement line for your ribbon loop attachment. It is a placement line to show you where you should place your back piece of your pouch. It’s easy for your embroidery machine to get hung up on the fold so you want to tape these openings down so that your presser foot doesn’t get stuck. Tape down the fabric to the stabilizer there the folded edges come together. You are going to be stitching the pouch together and you don’t want the zipper pull to be left out of the pouch. VERY IMPORTANT! Move the zipper pull to the center of the zipper. If you want to add a name or a monogram to the front of the pouch, then exit the design and stitch it out on the large panel you just stitched down. This stitching will attach the fabric to the zipper. Tape in place, then start the next round of stitching. The folds that you pressed into these two pieces of fabric should line up over the center of the zipper. The smaller piece should cover the smaller area above the zipper and the larger piece should cover the larger area below the zipper. Stick the two front pieces of fabric to your stabilizer. This will attach your zipper to the stabilizer Your zipper should obscure the two parallel lines. Also make sure that the metal end piece is away from the end of the parallel lines. Make sure that the zipper pull is outside of the parallel lines of stitching. When the stitching is done, stick your zipper onto the stabilizer. This will be a placement line for your zipper. Then score the inside edge of the stabilizer around the hoop to make a light tear so that you can peel back the paper and expose the sticky surface. Hoop a piece of sticky back stabilizer, making sure it is taut. You will not need to press the back piece of your pouch. These are the pieces that are 7.5″ x 3″ and 7.5″ x 5″ Fold over 1/2″ of fabric along the long edge, then press. Prepare your two fabric pieces for the front of your pouch. And if it does, it’s a lot easier to prevent a disaster if your machine is running a slowly. It’s easy for an embroidery machine to get hung up on all these layers you are putting together. Tip: Slow down your machine when you assemble this project. For the smallest pouch that can be stitched out in a 5″ x 7″ hoop, an 8″ zipper should work well.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |